Im in need of some guidance. I am ghosting an older HDD from and older PC to a new HDD in a newer PC. I have run in to the problem of my new HDD after the clone is not booting. I now know ( I think) it is because I didnt run a sysprep. The new HDD will boot in the old PC just fine.
This is my first time doing this so I expected something to go wrong. I would like to know the proper steps to take in preparation. I dont know how to use sysprep and google is getting a little confusing.
How do I use sysprep to get my HDDs ready?
Do I sysprep the source drive or the destination drive?
I am using symantec ghost to clone the drive and I did not plan on imaging. I was just going to do a straight clone. Thank you in advance.